The International Archives of the Photogrammetry, Remote Sensing and Spatial Information Sciences
Download
Publications Copernicus
Download
Citation
Articles | Volume XLIII-B2-2020
Int. Arch. Photogramm. Remote Sens. Spatial Inf. Sci., XLIII-B2-2020, 963–968, 2020
https://doi.org/10.5194/isprs-archives-XLIII-B2-2020-963-2020
Int. Arch. Photogramm. Remote Sens. Spatial Inf. Sci., XLIII-B2-2020, 963–968, 2020
https://doi.org/10.5194/isprs-archives-XLIII-B2-2020-963-2020

  12 Aug 2020

12 Aug 2020

OPTICAL 3D MEASUREMENTS IN HYDRODYNAMIC TUNNEL FOR AIRCRAFT ICING STUDY

V. A. Knyaz1,2, D. G. Stepaniants1, E. V. Ippolitov3, and M. M. Novikov3 V. A. Knyaz et al.
  • 1State Research Institute of Aviation System (GosNIIAS), 125319 Moscow, Russia
  • 2Moscow Institute of Physics and Technology (MIPT), Russia
  • 3Institute on Laser and Information Technologies of RAS – Branch Research Centre Crystallography and Photonics of RAS, Shatura, Russia

Keywords: image-based 3D measurements, calibration, accuracy, hydrodynamic tunnel, aircraft icing, multimedia imaging

Abstract. The study of how aircraft icing influences on aircraft aerodynamic performance is very important for developing measures and recommendation to improve aircraft flight safety. The effective method of aerodynamic processes modeling is experiment in wind (aerodynamic) tunnel or water (hydrodynamic) tunnel. They allow to perform experiments with a scaled model of an aircraft affected by icing and to visualize the wing flow process and changes caused by icing. While visualization of the wing flow yields useful qualitative information about flow, it is more important to retrieve quantitative 3D data of flow, which allows to forecast icing process and to develop anti-icing techniques and recommendations.

The presented study addresses to creating an photogrammetric system and 3D measurement techniques for quantitate evaluation of 3D flow parameters in a hydrodynamic tunnel for aircraft icing influence exploration. Being an initial part of a long-term research project, this study is aimed at developing of an accurate calibration technique of the photogrammetric system for 3D measurement in condition of two optical media interfaces. The developed algorithms for imaging process through two optical media interfaces are used in calibration procedure and object 3D coordinates measuring. The results of the photogrammetric system calibration are given in comparison with standard (single media) case. Experimental 3D reconstruction of a typical object demonstrated high accuracy of the developed algorithms.