Volume XLII-5/W3
Int. Arch. Photogramm. Remote Sens. Spatial Inf. Sci., XLII-5/W3, 27–31, 2019
https://doi.org/10.5194/isprs-archives-XLII-5-W3-27-2019
© Author(s) 2019. This work is distributed under
the Creative Commons Attribution 4.0 License.
Int. Arch. Photogramm. Remote Sens. Spatial Inf. Sci., XLII-5/W3, 27–31, 2019
https://doi.org/10.5194/isprs-archives-XLII-5-W3-27-2019
© Author(s) 2019. This work is distributed under
the Creative Commons Attribution 4.0 License.

  05 Dec 2019

05 Dec 2019

ANALYSIS OF POSSIBILITIES OF LOW-COST PHOTOGRAMMETRY FOR INTERIOR MAPPING

A. Dlesk1, K. Vach2, and P. Holubec2 A. Dlesk et al.
  • 1Department of Geomatics, CTU in Prague, Czechia
  • 2EuroGV s.r.o.

Keywords: Photogrammetry, Interior mapping, Exposure, SfM, BIM, fisheye lens

Abstract. This paper shows the possibilities of using low-cost photogrammetry for interior mapping as a tool to gather fast and accurate data for 3D modelling and BIM. To create a 3D model of a building interior with a high level of detail requires techniques such as laser scanning and photogrammetry. In the case of photogrammetry, it is possible to use standard cameras and SfM software to create an accurate point cloud which can be used for 3D modelling and then for BIM. The images captured indoor are often captured under lower light conditions. Using different exposure during capturing of images of building interior was tested. Frequent plain walls of a building interior cause that the images are usually lack of any features and their photogrammetric processing is getting much more difficult. In some cases, results of photogrammetric processing are poor and inaccurate. In this paper, an experiment of creating a 3D model of a building interior using photogrammetric processing of images was carried out. For this experiment digital camera with two different lenses (16 mm lens and fisheye lens) was used. For photogrammetric processing were chosen different software. All the results were compared to each other and to the laser scanning data of the interior. At the end of the paper, the discussion of the advantages and disadvantages of the shown method has been made.