Volume XLII-1/W1
Int. Arch. Photogramm. Remote Sens. Spatial Inf. Sci., XLII-1/W1, 425-431, 2017
https://doi.org/10.5194/isprs-archives-XLII-1-W1-425-2017
© Author(s) 2017. This work is distributed under
the Creative Commons Attribution 3.0 License.
Int. Arch. Photogramm. Remote Sens. Spatial Inf. Sci., XLII-1/W1, 425-431, 2017
https://doi.org/10.5194/isprs-archives-XLII-1-W1-425-2017
© Author(s) 2017. This work is distributed under
the Creative Commons Attribution 3.0 License.

  31 May 2017

31 May 2017

EXTRACTING URBAN MORPHOLOGY FOR ATMOSPHERIC MODELING FROM MULTISPECTRAL AND SAR SATELLITE IMAGERY

S. Wittke1, K. Karila1, E. Puttonen1, A. Hellsten2, M. Auvinen2,3, and M. Karjalainen1 S. Wittke et al.
  • 1Finnish Geospatial Research Institute, 02430 Masala, Finland
  • 2Finnish Meteorological Institute, 00101 Helsinki, Finland
  • 3Department of Physics, University of Helsinki, Finland

Keywords: Urban Morphology, Land Cover Classification, Digital Surface Model, Sentinel-2, TanDEM-X, Satellite Remote Sensing

Abstract. This paper presents an approach designed to derive an urban morphology map from satellite data while aiming to minimize the cost of data and user interference. The approach will help to provide updates to the current morphological databases around the world. The proposed urban morphology maps consist of two layers: 1) Digital Elevation Model (DEM) and 2) land cover map.

Sentinel-2 data was used to create a land cover map, which was realized through image classification using optical range indices calculated from image data. For the purpose of atmospheric modeling, the most important classes are water and vegetation areas. The rest of the area includes bare soil and built-up areas among others, and they were merged into one class in the end. The classification result was validated with ground truth data collected both from field measurements and aerial imagery. The overall classification accuracy for the three classes is 91 %.

TanDEM-X data was processed into two DEMs with different grid sizes using interferometric SAR processing. The resulting DEM has a RMSE of 3.2 meters compared to a high resolution DEM, which was estimated through 20 control points in flat areas. Comparing the derived DEM with the ground truth DEM from airborne LIDAR data, it can be seen that the street canyons, that are of high importance for urban atmospheric modeling are not detectable in the TanDEM-X DEM. However, the derived DEM is suitable for a class of urban atmospheric models.

Based on the numerical modeling needs for regional atmospheric pollutant dispersion studies, the generated files enable the extraction of relevant parametrizations, such as Urban Canopy Parameters (UCP).