Int. Arch. Photogramm. Remote Sens. Spatial Inf. Sci., XLI-B8, 163-168, 2016
https://doi.org/10.5194/isprs-archives-XLI-B8-163-2016
© Author(s) 2016. This work is distributed under
the Creative Commons Attribution 3.0 License.
 
22 Jun 2016
RADIOACTIVE POLLUTION ESTIMATE FOR FUKUSHIMA NUCLEAR POWER PLANT BY A PARTICLE MODEL
Keisuke Saito and Susumu Ogawa aNagasaki University, Graduate school of engineering, Bunkyo-machi, Nagasaki, 852-8521 Japan
Keywords: Fukushima, Radioactive pollution, Particle model Abstract. On Mar 12, 2011, very wide radioactive pollution occurred by a hydrogen explosion in Fukushima Nuclear Power Plant. A large amount of radioisotopes started with four times of explosions. With traditional atmospheric diffusion models could not reconstruct radioactive pollution in Fukushima. Then, with a particle model, this accident was reconstructed from meteorological archive and Radar- AMeDAS. Calculations with the particle model were carried out for Mar 12, 15, 18 and 20 when east southeast winds blew for five hours continuously. Meteorological archive is expressed by wind speeds and directions in five-km grid every hour with eight classes of height till 3000 m. Radar- AMeDAS is precipitation data in one-km grid every thirty minutes. Particles are ten scales of 0.01 to 0.1 mm in diameter with specific weight of 2.65 and vertical speeds given by Stokes equation. But, on Mar 15, it rained from 16:30 and then the particles fell down at a moment as wet deposit in calculation. On the other hand, the altitudes on the ground were given by DEM with 1 km-grid. The spatial dose by emitted radioisotopes was referred to the observation data at monitoring posts of Tokyo Electric Power Company. The falling points of radioisotopes were expressed on the map using the particle model. As a result, the same distributions were obtained as the surface spatial dose of radioisotopes in aero-monitoring by Ministry of Education, Culture, Sports, Science and Technology. Especially, on Mar 15, the simulated pollution fitted to the observation, which extended to the northwest of Fukushima Daiichi Nuclear Power Plant and caused mainly sever pollution. By the particle model, the falling positions on the ground were estimated each particle size. Particles with more than 0.05 mm of size were affected by the topography and blocked by the mountains with the altitudes of more than 700 m. The particle model does not include the atmospheric stability, the source height, and deposit speeds. The present assignment is how to express the difference of deposition each nucleus.
Conference paper (PDF, 2065 KB)


Citation: Saito, K. and Ogawa, S.: RADIOACTIVE POLLUTION ESTIMATE FOR FUKUSHIMA NUCLEAR POWER PLANT BY A PARTICLE MODEL, Int. Arch. Photogramm. Remote Sens. Spatial Inf. Sci., XLI-B8, 163-168, https://doi.org/10.5194/isprs-archives-XLI-B8-163-2016, 2016.

BibTeX EndNote Reference Manager XML