The International Archives of the Photogrammetry, Remote Sensing and Spatial Information Sciences
Download
Publications Copernicus
Download
Citation
Articles | Volume XLI-B5
Int. Arch. Photogramm. Remote Sens. Spatial Inf. Sci., XLI-B5, 841–847, 2016
https://doi.org/10.5194/isprs-archives-XLI-B5-841-2016
Int. Arch. Photogramm. Remote Sens. Spatial Inf. Sci., XLI-B5, 841–847, 2016
https://doi.org/10.5194/isprs-archives-XLI-B5-841-2016

  16 Jun 2016

16 Jun 2016

4D ANIMATION RECONSTRUCTION FROM MULTI-CAMERA COORDINATES TRANSFORMATION

J. P. Jhan1, J. Y. Rau1, and C. M. Chou2 J. P. Jhan et al.
  • 1Department of Geomatics, National Cheng Kung University, Tainan, Taiwan
  • 2Kuo Toong International CO., LTD., Taiwan

Keywords: Close-Range Photogrammetry, Conformal Transformation, 4D Animation

Abstract. Reservoir dredging issues are important to extend the life of reservoir. The most effective and cost reduction way is to construct a tunnel to desilt the bottom sediment. Conventional technique is to construct a cofferdam to separate the water, construct the intake of tunnel inside and remove the cofferdam afterwards. In Taiwan, the ZengWen reservoir dredging project will install an Elephant-trunk Steel Pipe (ETSP) in the water to connect the desilting tunnel without building the cofferdam. Since the installation is critical to the whole project, a 1:20 model was built to simulate the installation steps in a towing tank, i.e. launching, dragging, water injection, and sinking. To increase the construction safety, photogrammetry technic is adopted to record images during the simulation, compute its transformation parameters for dynamic analysis and reconstruct the 4D animations. In this study, several Australis© coded targets are fixed on the surface of ETSP for auto-recognition and measurement. The cameras orientations are computed by space resection where the 3D coordinates of coded targets are measured. Two approaches for motion parameters computation are proposed, i.e. performing 3D conformal transformation from the coordinates of cameras and relative orientation computation by the orientation of single camera. Experimental results show the 3D conformal transformation can achieve sub-mm simulation results, and relative orientation computation shows the flexibility for dynamic motion analysis which is easier and more efficiency.