Int. Arch. Photogramm. Remote Sens. Spatial Inf. Sci., XL-8, 827-832, 2014
https://doi.org/10.5194/isprsarchives-XL-8-827-2014
© Author(s) 2014. This work is distributed under
the Creative Commons Attribution 3.0 License.
 
28 Nov 2014
Target detection algorithm for airborne thermal hyperspectral data
R. Marwaha, A. Kumar, P. L. N. Raju, and Y. V. N. Krishna Murthy Indian Institute of Remote Sensing, (ISRO) Dehradun, India
Keywords: Thermal Hyperspectral, LWIR (Long Wave Infrared), Constrained Energy Minimization (CEM), Minimum Noise Fraction (MNF) Abstract. Airborne hyperspectral imaging is constantly being used for classification purpose. But airborne thermal hyperspectral image usually is a challenge for conventional classification approaches. The Telops Hyper-Cam sensor is an interferometer-based imaging system that helps in the spatial and spectral analysis of targets utilizing a single sensor. It is based on the technology of Fourier-transform which yields high spectral resolution and enables high accuracy radiometric calibration. The Hypercam instrument has 84 spectral bands in the 868 cm−1 to 1280 cm−1 region (7.8 μm to 11.5 μm), at a spectral resolution of 6 cm−1 (full-width-half-maximum) for LWIR (long wave infrared) range. Due to the Hughes effect, only a few classifiers are able to handle high dimensional classification task. MNF (Minimum Noise Fraction) rotation is a data dimensionality reducing approach to segregate noise in the data. In this, the component selection of minimum noise fraction (MNF) rotation transformation was analyzed in terms of classification accuracy using constrained energy minimization (CEM) algorithm as a classifier for Airborne thermal hyperspectral image and for the combination of airborne LWIR hyperspectral image and color digital photograph. On comparing the accuracy of all the classified images for airborne LWIR hyperspectral image and combination of Airborne LWIR hyperspectral image with colored digital photograph, it was found that accuracy was highest for MNF component equal to twenty. The accuracy increased by using the combination of airborne LWIR hyperspectral image with colored digital photograph instead of using LWIR data alone.
Conference paper (PDF, 993 KB)


Citation: Marwaha, R., Kumar, A., Raju, P. L. N., and Krishna Murthy, Y. V. N.: Target detection algorithm for airborne thermal hyperspectral data, Int. Arch. Photogramm. Remote Sens. Spatial Inf. Sci., XL-8, 827-832, https://doi.org/10.5194/isprsarchives-XL-8-827-2014, 2014.

BibTeX EndNote Reference Manager XML