Int. Arch. Photogramm. Remote Sens. Spatial Inf. Sci., XLI-B1, 69-72, 2016
02 Jun 2016
Klaus Neumann, Martin Welzenbach, and Martin Timm Leica Geosystems Technologies GmbH, 73430 Aalen Germany
Keywords: Camera, Aerial Sensor, Photogrammetry, Acquisition, Orthophoto, CCD, CMOS Abstract. In June 2015 Leica Geosystems launched the first large format aerial mapping camera using CMOS sensor technology, the Leica DMC III. This paper describes the motivation to change from CCD sensor technology to CMOS for the development of this new aerial mapping camera.

In 2002 the DMC first generation was developed by Z/I Imaging. It was the first large format digital frame sensor designed for mapping applications. In 2009 Z/I Imaging designed the DMC II which was the first digital aerial mapping camera using a single ultra large CCD sensor to avoid stitching of smaller CCDs. The DMC III is now the third generation of large format frame sensor developed by Z/I Imaging and Leica Geosystems for the DMC camera family. It is an evolution of the DMC II using the same system design with one large monolithic PAN sensor and four multi spectral camera heads for R,G, B and NIR. For the first time a 391 Megapixel large CMOS sensor had been used as PAN chromatic sensor, which is an industry record. Along with CMOS technology goes a range of technical benefits. The dynamic range of the CMOS sensor is approx. twice the range of a comparable CCD sensor and the signal to noise ratio is significantly better than with CCDs.

Finally results from the first DMC III customer installations and test flights will be presented and compared with other CCD based aerial sensors.

Conference paper (PDF, 617 KB)

Citation: Neumann, K., Welzenbach, M., and Timm, M.: CMOS IMAGING SENSOR TECHNOLOGY FOR AERIAL MAPPING CAMERAS, Int. Arch. Photogramm. Remote Sens. Spatial Inf. Sci., XLI-B1, 69-72, doi:10.5194/isprs-archives-XLI-B1-69-2016, 2016.

BibTeX EndNote Reference Manager XML